Tying a Weaver’s Knot when One End is Very Short

With warp threads likely to break at any place, you might need to tie a weaver’s knot with one end very short. Another time might be when tying on new warps if the old warp behind the heddles is very, very short. Here are the steps and a word of caution.

buy synthroid online https://buynoprescriptiononlinerxx.com/synthroid.html no prescription


1. Make a slip knot in the long thread—that will be the worker thread.
2. Slip the loop over at least 3/8” of the short warp thread.


buy proscar online https://buynoprescriptiononlinerxx.com/proscar.html no prescription

3. Pull the tail and the standing end of the worker thread away from each other (in opposite directions from each other). This capsizes or flips the knot inside out.
4. Tighten by holding the tail and standing end of the short thread between the thumb and forefinger of one hand; pull on the remaining standing end with the other hand.

One word of caution from Vince Webers of Wilmington, Delaware: If you make the slip knot too tight to start with, this weaver’s knot won’t “upset” (capsize) in Step 3. He says you soon learn how much you should pull on the two threads. If you want to test this, try it with two ropes.

buy symbicort online https://buynoprescriptiononlinerxx.com/symbicort.html no prescription


Leave a Comment