Knots, Knots and More Knots

Introduction:
“Linda Doggett’s knot” in my previous post led me to this post on more knots. A couple of years ago my tech guy suggested we make a Kindle booklet on hemstitching since it was the number one inquiry in my weaving tips section on my website. I use it at my loom every time I do hemstitching. The second booklet is on knots—something I thought really would be useful right next to the loom on an iPhone, or other devices.

The slip knot is my absolute favorite knot. I can remember the days when how to tie it was so elusive. It was shown to me over and over but I just didn’t “get” it for a long time.  I guess I learned it by trial and error until it became as familiar as my right hand; my hands knew how to tie it.  It was a big part of the motivation to include a knots chapter in my book, Warping Your Loom & Tying On New Warps.  I wanted to SHOW how it was tied so others could learn it. I’ve included it below. (The whole knots chapter is in the Kindle booklet. See below.)

Slip knot
A slip knot is a temporary knot that secures a single thread or groups of threads. Its  reatest asset is that it can be quickly untied with a jerk with one hand. It’s often used to tie groups of warp ends after they have been threaded in the heddles so they won’t slip out. Every weaver should know the slip knot because it is used so often—whenever you want to secure something temporarily. It’s my favorite knot, and it’s the one I almost  always automatically tie—just in case I’ll need to undo it.

To make a slip knot: To make the first loop, you can use either the tail or the standing end, whichever seems easier to tie in the situation. In this example I’m using the standing end, but you could just as easily make the loop with the tail and proceed as follows.

  1. Make a loop. (I take the standing end over the back of my left hand or over a few fingers and cross the standing end on top of the tail of the string.) Hold where the  hreads cross in a pinch between your thumb and forefinger.
  1. Reach through the loop with the right forefinger and thumb and grasp the standing end and pull it through the loop, so that it makes a loop within the first loop. (If you were to begin the knot with the tail making the first loop, and the tail were being drawn through as the second loop, make sure you pull the tail only part way through, not completely through. If you pulled the tail through, you wouldn’t have the second loop.)
  1. Be sure to tighten the knot until you feel it bite. To do that you pull the loop and the tail in opposite directions.

To release the knot: Just jerk on the end you made the loops with, in this case the standing end.

I made this little booklet so you could have it on your iPhone or other devices. Want to know how to tie a weaver’s knot? There are 3 ways shown as well as “how to undo a weaver’s knot. Of course, square and granny knots are included, as is the lark’s head knot, and other knots for weavers. I like it because you can have it at the loom up close when you need it. The cost is $2.99 and you can order from my website. 

2 thoughts on “Knots, Knots and More Knots

  1. Thank you, Peggy! Your tips are always so helpful! I have pulled your books off my shelf innumerable times when I’m warping and weaving. They are my favorite weaving help books!

Leave a Reply

Your email address will not be published. Required fields are marked *