Here is a welcome response to my post about how much weight to use for using croc clips instead of a temple to hold out the width of the warp. You can read a summary of my post, below. Read more about temples in the tip section. The illustration here is from “Weaving for Beginners” on page 312.
Thank you so much! I have 3 lbs on each side right now, weaving with JaggerSpun Zephyr. It seems to be just right. I started with a temple, but it is one of the new Glimakra ones, these have mean thick teeth that no matter what seem to damage the cloth. The older ones have nice small teeth that cause no damage. That is why I am using the clips. I was uncertain, it was working, but…..was it right? Now I know it is for sure. thanks again!
Here’s a summary of my post.
“I have a question on the weight to put when using the crocodile clamps in place of a temple. …”
I’m not sure of an amount of weight to tell you. You want plenty of weight, that’s for sure–probably more than a pound on each side. What you want to achieve is to have the warp spread out to the width it is in the reed. You need whatever it takes to accomplish that. So much depends on the situation, such as, how wide is the warp and how much does the cloth draw in? I have a lot to say about draw-in in my new book, “Weaving for Beginners“–over 12 entries in the index. (Too much tension on the warp can cause too much draw-in, for example.)
A weaving friend suggested that if you have a very wide warp it probably would be better to use an actual temple to be strong enough to hold out the warp wide enough. (There is a limit to the amount of weight croc clips can hold.)
better to use an actual temple to be strong enough to hold out the warp wide enough. (There is a limit to the amount of weight croc clips can hold.)